 Q: Can I store my vehicle with the monitor on?
A: The Monitor draws 25mA to 150mA of power. It's possible the Monitor could drain the vehicle's battery over an extended period of time. If storing for more than 1 month, it's advised to unplug Monitor and remove Sensors. Plug in Monitor and replace Sensors before driving again.
Q: Can I use a sealant or equalizer powder in the tire with PressurePro?
A: It's recommended to use a filtered Dill Valve if using sealants or equalizing substances. Sealant can plug up the valve core and shut off pressures in stems.
Q: Can the monitor be used independently on the front/back vehicle?
A: Yes the monitor can be used separately
Q: Do I need to rebalance my tires when using a sensor?
A: The 2/3 oz. Sensors, on large tires (RV/Truck), seldom requires a tire be balanced. However, smaller tires may require a 1/2 ounce stick-on balancing weight opposite the Sensor.
Q: Does monitor need to be powered by lighter accessory?
A: No. Hardwiring is a preferred option as it reduces back feed interference. Connect the red wire to a 12-volt DC positive power source (direct wire to the battery is not required). The black wire should be connected to a ground or chassis.
Q: When does the sensor transmit?
A:
1. Within 60 seconds of screwing Sensor onto the valve stem.
2. Every 5 minutes while updating, under normal conditions.
3. At a 12.5% drop from baseline pressure.
4. At a 25% drop from baseline pressure.
5. At the Upper Pressure alert level.
6. When a Sensor is removed from its valve stem.
Q: How reliable is PressurePro for different types of vehicles and conditions?
A: PessurePro has been designed and tested to work under all types of conditions.
Q: Can I monitor an RV and a towed vehicle at the same time?
A: Yes. PressurePro will read the RV and a vehicle it tows. PressurePro will work on all types of vehicles with up to 34 wheel positions if needed.
Q: How strong is the signal?
A: PressurePro will read up to 100 feet under most conditions. Radio signals have restrictions placed by law and PressurePro complies with all regulations and FCC guidelines. The signal from the sensor is strong and specific to the receiver, which is tuned for sensitivity to the sensor signal.
|
|
|
|
